Pickup/Wah Type- The Value buttons select the Pick Up or Wah type that is simulated.
SH- Gives a single coil pick up the warm tone of a humbucker.
![1747 1747](/uploads/1/2/6/4/126403333/594731517.jpg)
HS- Gives a humbucker the unique sound of a single coil.
bo- Boutique Wah is a wider sweeping Wah with a more modern sound.
Electronics service manual exchange: schematics,datasheets,diagrams,repairs,schema,service manuals,eeprom bins,pcb as well as service mode entry, make to model and chassis correspondence and more.
Fr- Full Range Wah sweeps the entire spectrum of audible frequencies.
A Compressor is used to automatically limit the dynamic level of the guitar signal.
1to 15- Controls the amount of compression (ratio and sustain) and ranges
from 1 (slight compression) through infinity (maximum sustain) or
Amp/Cabinet Modeling
Amp Modeling is a technology that applies the tones of several popular modern and vintage
amps and acoustic guitar simulation.Values 1-9 increase the amp’s gain and level.
Any trademarks are the property of their respective companies and are in no way associated with DigiTech.
o1-o9- Based on Boutique
H1-h9- Based on a Hot Rod
C1-C9- Based on a British Combo
s1-s9- Based on a British Stack
G1-g9- Based on High Gain tube amp
AC- A flat top acoustic guitar
The Tuner in the RP50 lets you quickly tune or check the tuning of your guitar.Enter the
Tuner by pressing and holding both Footswitches simultaneously.Thetu briefly displays
indicating that you are in Tuner mode.To begin tuning,play a note on your guitar (the neck
pickup usually works best).The display shows the note being played.The Effect LEDs
indicate whether the note is sharp or flat.The right 6 red LEDs indicate the note is sharp
and should be tuned down.The left 6 red LEDs indicate the note is flat and should be
tuned up.The center Green LED indicates the note is in tune.The output is muted in
![Digitech Ar 1747 User Manual Digitech Ar 1747 User Manual](/uploads/1/2/6/4/126403333/545099536.jpg)
When the Tuner is enabled,you can change your tuning reference.The default factory
setting is A=440 Hz.(displayed as 40).Press the Value Buttons to select alternate dropped
tunings.Alternate tunings are A = Ab (displayed as Ab),A = G (displayed as G),and A = Gb
The display shows the note played.
of the EQ LED
LEDs to the right
indicate the note is sharp.
the note is in tune.